Dragonfly and Cattails Scroll Saw Pattern
Free printable dragonfly and cattails scroll saw pattern from Sheetwise (plycutplan.com): a 6.88 × 7.5 in fretwork design with 19 blade-entry holes, rated beginner.


How to cut this pattern
- Print the PDF at 100% and check the 1 inch square.
- Cut a 7.88 × 8.5 in blank of 1/4 in (6 mm) Baltic birch plywood, sand the face and attach the pattern with spray adhesive or over painter’s tape.
- Black areas are the finished wood; every enclosed white area is waste.
- Drill 19 entry holes with a 1/16 in or 5/64 in (1.5–2 mm) bit, one inside each white area.
- Cut the interior openings first with a #3 or #5 reverse-tooth blade, working from the centre outwards, then cut the outer edge last.
- Peel off the pattern and sand lightly. Back delicate pieces with thin plywood if you will hang them.
Scaling: keep the long side at 6.25 in or more so the narrow bridges stay about 2.5 mm wide.
Wood for a batch
Each 7.88 × 8.5 in blank (design plus ½ in margin all round), with ⅛ in saw kerf between blanks:
- 12 × 12 in sheet: 1 blank
- 12 × 24 in sheet: 3 blanks
- 24 × 48 in sheet: 15 blanks
For mixed sizes, enter your blanks in the free plywood cut calculator.
Questions
Is this pattern free?
Yes. The Letter and A4 PDFs are free. Free for personal use. You may sell the finished pieces you make. Please do not share, resell or re-upload the pattern files.
Can I cut it on a laser?
Yes. The vector SVG is sized at 6.88 × 7.5 in and is a single connected shape, so it cuts out in one piece. The SVG is included with the 7-day Project Pass.
How was it made?
Designs are drawn with AI image tools, then cleaned and measured by our own software: it removes floating pieces, counts entry holes and finds the narrow bridges at the printed size. Check the printout before you cut.
More scroll saw patterns
All scroll saw patterns · Butterfly and Insect scroll saw patterns · Laser cut files (SVG)